Handling the X-Headstage

Handling the X-Headstage

Properly handling the X-Headstage will prolong its lifetime and reliability. 


To plugin connect the EIB/Probe/Adapter, align the two units directly on top of each other and exert equal force along the entire area. If the connectors are plugged in properly, there will be a satisfying lock feel. Make sure a good connection is established before screwing the X-Headstage with standard armor into an adapter. 


To detach the EIB/adapter from the headstage, use a small flat screwdriver and tilt the EIB or probe boards away from the X-Headstage from either the top (HDMI or Omnetics connector) or bottom side. Do not push the EIB/probe along the side (the long side).


To plugin the cable, exert some pressure on the HDMI/Omnetics connector to minimize any tear between the stacks of PCBs in the X-Headstage. This is particularly important for X-Headstage without armor protection.


    • Related Articles

    • Is armor necessary for the X-Headstage?

      It is possible to use the X-Headstage without the armor, but having an additional layer will offer additional mechanical protection and will likely prolong its lifetime.

    • Notes on X-Headstage IP68 rating

      The X-Headstage has been tested for IP68 rating by a third party (test report here). The rating is achieved with the following: An IP armor is configured with the headstage The optional moisture resistance coating must be specified at the time of the ...

    • Selecting and Configuring the X-Headstage

      Currently, KONTEX offers several types of X-Headstages X3R32: 32ch recording headstage X3R64: 64ch recording headstage XeR64: e-series 64ch recording headstage XeSR16: e-series 16ch switchable stimulation + recording headstage XeSR32: e-series 32ch ...

    • Can the X-Headstage be configured with an Omnetics connector?

      X-Headstage can be configured with a 12-pin Omnetics connector. However, we strongly recommend that new users consider the µHDMI connector. It is easy to plug in and unplug and uses a low-cost, flexible cable.

    • How do I interface the electrode with the X-Headstage?

      If you make your electrode, we offer EIBs with a direct interface to the X-Headstage. If the existing EIB designs do not satisfy your research needs, contact us for customization. There is a selection of off-the-shelf adapters for commonly used ...